Wemos D1 clone: digitalRead is unreliable - General Electronics - Arduino Forum

Hey there, not sure if it's the correct category, but I believe this is an electronic issue: I have two buttons hooked up to pin D3 and D4 of my Wemos D1 mini clone (these are the pull-up pins) that connect to GND when closed. Closing a button is supposed to change the direction of a motor through an ESC hooked to pin D0. I measured the voltage over D3 und D4 and GND and they're both nicely pulled up to 3.3V. However, the Motor is continuously changing directions (not very often but every 3-10

Wemos Arduino UNO Clone with WiFi

Overview, Adafruit FunHouse

PCB Review Request] Arduino Mega 2560 Clone + WEMOS D1 Central

Getting Started With Arduino: Beginner's Complete Guide

The Answer is 42!!: Arduino LC Meter Shield

What are some cheaper alternatives to the Arduino UNO R3 that have

Is there a simple way to use the 16 key touchpad (TTP229) with

Daniel Eichhorn – Squix – TechBlog

Wemos D1 Mini With Multiplexer Solved Blynk Community, 52% OFF

Arduino Bike Speedometer : 16 Steps (with Pictures) - Instructables

WeMos D1 CH340 WiFi Arduino UNO R3 Development Board ESP8266 ESP

14. Networking and communications - Tessel Renzenbrink

Posts with «github» label

Is there a simple way to use the 16 key touchpad (TTP229) with

wemos d1 mini - digitalRead true even when switch not activated